Lybrary.com: ebooks and download videos Search All  Title  Author 
Home / Nonfiction / Science / Applied Sciences

Genifuel Hydrothermal Processing Bench-Scale Technology Evaluation Report

$49.99
| £40.43 | €47.81 | Ca$67.84 | Au$68.64
by Philip Marrone
What is this?DRM-PDF | by download   add to wish list
Genifuel Hydrothermal Processing Bench-Scale Technology Evaluation Report by Philip Marrone

Hydrothermal Liquefaction (HTL) and Catalytic Hydrothermal Gasification (CHG) proof-of-concept bench-scale tests were performed to assess the potential of the Genifuel hydrothermal process technology for handling municipal wastewater sludge. HTL tests were conducted at 300-350?C and 2900 psig on three different feeds: primary sludge (11.9 wt% solids), secondary sludge (9.7 wt% solids), and post-digester sludge (also referred to as digested solids) (16.0 wt% solids). Corresponding CHG tests were conducted at 350?C and 2900 psig on the HTL aqueous phase product using a ruthenium based catalyst. A comprehensive analysis of all feed and effluent phases was also performed. Total mass and carbon balances closed to within ± 15% in all but one case. Biocrude yields from HTL tests were 37%, 25%, and 34% for primary sludge, secondary sludge, and digested solids feeds, respectively. The biocrude yields accounted for 59%, 39%, and 49% of the carbon in the feed for primary sludge, secondary sludge, and digested solids feeds, respectively. It should be noted that HTL test results for secondary sludge may have been affected by equipment problems. Biocrude composition and quality were comparable to that seen with biocrudes generated from algae feeds. CHG product gas consisted primarily of methane, with methane yields (relative to CHG input) on a carbon basis of 47%, 61%, and 64% for aqueous feeds that were the product of HTL tests with primary sludge, secondary sludge, and digested solids, respectively. Siloxane concentrations in the CHG product gas were below the detection limit and well below fuel input composition limits set by several engine manufacturers. Relative to that of the sludge feeds, the HTL-CHG process resulted in a reduction in chemical oxygen demand (COD) of greater than 99.9% and a reduction in residual solids for disposal of 94-99%. The test results, as a whole, support further long-term testing in a larger scale integrated system that is representative of what would be installed at a water resource recovery facility (WRRF) in order to fully assess the technical and economic viability of this technology for wastewater sludge treatment

To view this DRM protected ebook on your desktop or laptop you will need to have Adobe Digital Editions installed. It is a free software. We also strongly recommend that you sign up for an AdobeID at the Adobe website. For more details please see FAQ 1&2. To view this ebook on an iPhone, iPad or Android mobile device you will need the Adobe Digital Editions app, or BlueFire Reader or Txtr app. These are free, too. For more details see this article.


SHARE  Share by Email  Share on Facebook  Share on Twitter  Share on Linked In  Share on Delicious
or call in the US toll free 1-888-866-9150 product ID: 888297

Ebook Details
Pages: 202
Size: 12.5 MB
Publisher: IWA Publishing
Date published:   2016
ISBN: 9781780408408 (DRM-PDF)

DRM Settings
Copying:not allowed
Printing:not allowed
Read Aloud:  not allowed

This product is listed in the following categories:

Nonfiction > Science > Environmental Science
Nonfiction > Technology > Mining
Nonfiction > Science > Applied Sciences

If you find anything wrong with this product listing, perhaps the description is wrong, the author is incorrect, or it is listed in the wrong category, then please contact us. We will promptly address your feedback.

Submit 5 page SummaryWhat is this?

12/07/2016
© 2016 Lybrary.com